Supermicro SSE-F3548S - RADIUS Server

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
330
Re-transmit
3
Key
None
13.2.1 RADIUS Server
Supermicro switches function as a RADIUS client. The RADIUS server to be contacted for authentication
can be configured in the switch.
Follow the steps below to configure RADIUSserver Parameters.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
radius-server host <ip-address> [timeout <1-120>]
[retransmit <1-254>] key <secret-key-string> [type
{authenticating | accounting | both}]
Configure RADIUS server for purpose of
authenticating or accounting or both.
ip-address – serverIP address.
timeout – Specify RADIUS server
timeout in range 1-120
retransmit – Specify number of retries
to attempt to connect to RADIUS server
in range 1-254
key –Specify authentication key
Step 3
End
Exits the configuration mode.
Step 4
show radius server
show radius statistics
Displays the RADIUS configuration.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The “no radius-server host <ip-address>” command deletes the RADIUS client.
The example below shows the commands used to configure RADIUS server.
SMIS# configure terminal
SMIS(config)#radius-server host 200.200.200.1 timeout 50 retransmit 250 key key1
SMIS(config)# end
SMIS# show radius server
Radius Server Host Information
------------------------------