Supermicro SSE-F3548S - Switch Contact

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
281
The device name configuration is automatically stored as part of the startup configuration
file.
The example below shows the commands used to configure the switch name.
SMIS# configure terminal
SMIS(config)# device name switch1
switch1(config)# end
switch1# show system information
Switch Name: switch1
Switch Base MAC Address: 00:30:48:e3:70:bc
SNMP EngineID: 80.00.08.1c.04.46.53
System Contact: http://www.supermicro.com/support
System Location: Supermicro
Logging Option: Console Logging
Login Authentication Mode: Local
Snoop Forward Mode: MAC based
Config Restore Status: Not Initiated
Config Restore Option: No restore
Config Restore Filename: iss.conf
Config Save IP Address: 0.0.0.0
Device Up Time: 0 days 0 hrs 1 mins 11 secs
Boot-up Flash Area: Normal
NTP Broadcast Mode: No
[NTP] ntp is disabled
Server Key Prefer
=============== ===== ======
Key # Key
======= ====================================
Time zone offset not set
11.5.2 Switch Contact
Supermicro switches provide an option to configure the switch in charge Contact details, usually anemail
ID.
Follow the steps below to configure the switch contact.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
system contact <string - to use more than one
word, provide the string within double quotes>
Configures the switch contact.
String – Contact information entered as
a String of maximum length 256.
Step 3
End
Exits the configuration mode.
Step 4
show system information
Displays the system information