Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
The “no rmon alarm <number (1-65535)>” and“no rmon event <number (1-65535)>”
commandsdelete the RMON alarm configuration and RMON event configuration
respectively.
When the alarm variable is the MIB variable defined in the history group or the Ethernet
statistics group, RMON Ethernet statistics function or RMON history statistics function
should be configured on the particular Ethernet interface, elsethe creation of the alarm
entry fails, and no alarm event is triggered.
12.2.3 Configuring Statistics
The RMON Ethernet statistics group collects statistics for each monitored interface on the switch and
stores them in the Ethernet statistics table. Only one statistics entry can be createdper interface.
The RMON Ethernet history group collects a periodic statistical sampling of the data collected by the
Ethernet statistics group and stores them in the Ethernet history table. Multiple history entries can be
configured on one interface, however all should have different values.
Enters the configuration mode
interface
><
>
or
interface range <interface-type><interface-id> ….
(Optional) Enters the interface
configuration mode.
interface-type – may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range use a hyphen (-)
between the start and end interface
numbers. E.g.: int range fx 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range fx 0/1-10, fx 0/20
If multiple interfaces are provided, the
next step will perform the particular
configuration on all these interfaces.
rmon collection stats <index (1-65535)> [owner
<ownername (127)>]
(Optional) Enable RMON statistic
collection on the interface
index - Statistics table index, in range 1-
To Next Page
Loading...
