Supermicro SSE-F3548S - 12.2.5 Configuring Port Rate Limit

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
324
0 broadcast and 0 multicast packets,
0 undersized and 0 oversized packets,
0 fragments and 0 jabbers,
0 CRC alignment errors and 0 collisions,
# of dropped packet events is 0
Network utilization is estimated at 0
SMIS# write startup-config
Building configuration, Please wait. May take a few minutes ...
[OK]
SMIS# show running-config
Building configuration...
ID Hardware Version Firmware OS Boot Loader
0 SSE-F3548 1.0.0.0 6 0.0.0.0vlan 1
ports fx 0/1-24 untagged
ports cx 0/1-3 untagged
exit
set rmon enable
rmon event 1 description rise log owner smicro1 trap PUBLIC
rmon event 2 description fall log owner smicro1 trap NETMAN
rmon alarm 1 1.3.6.1.6.3.16.1.2.1.4.1.4.110.111.110.101 2 absolute rising-thresh
old 2 1 falling-threshold 1 2 owner smicro1
interface Fx 0/5
rmon collection stats 1 owner monitor
rmon collection history 1 buckets 2 interval 20
exit
12.2.5 Configuring Port Rate Limit
Rate limit is disabled by default in Supermicro switches. Follow the below steps to enable the port rate
limit.