Supermicro SSE-F3548S - Page 325

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
325
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
interface <interface-type><interface-id>
or
interface range <interface-type><interface-id> ….
(Optional) Enters the interface
configuration mode.
interface-type – may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range, use a hyphen (-)
between the start and end interface
numbers. E.g.: int range fx 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range fx 0/1-10, fx 0/20
If multiple interfaces are provided, the
next step will perform the particular
configuration on all these interfaces.
Step 3
rate-limit output <rate-value-kbps (1-
10000000)><burst-value-kbits (1-10000000)>
Enables the egress rate limit for the
interface(s), set to the closest rate
(kbps) and burst size (kbits) as the
hardware capabilities. Rate limiting is
applied to packets sent out on a
particular interface.
Rate limit and burst size in range of1-
10000000.
Step 4
End
Exits the configuration mode.
Step 5
show interface [{ [<interface-type><interface-id>]
rate-limit
Displays the rate limit configuration on
an interface
The “no rate-limit output” command disablesthe ratelimit on a particular interface.
The example below shows the commands used to configure the rate limit.
SMIS# configure terminal