Supermicro SSE-F3548S - 14.1.3 Configuring LLDP Timers

354 |341
Step 5
lldptlv-select dot3tlv { [macphy-config] [link-
aggregation] [max-framesize] }
(Optional)
Configure dot3 TLV types to be
transmitted on a port
macphy-config - MAC or PHY TLV.
link-aggregation - Link aggregation TLV.
max-framesize - Maximum frame size
TLV.
Step 6
End
Exits the configuration mode.
Step 7
show lldp interface [<interface-type><interface-
id>]
show lldp local {[<interface-type><interface-id>] |
[mgmt-addr]}
Displays LLDP configuration details on a
particular interface or all interfaces
Displays the current switch information
that will be used to populate outbound
LLDP advertisements for a specific
interface or all interfaces
14.1.3 Configuring LLDP Timers
Supermicro switches allow for user configuration of LLDP timers:
• Transmit Interval
• Holdtime Multiplier
• ReinitializationDelay
• Transmit Delay
• Notification Delay
14.1.3.1 Message Transmit Interval
The message transmit interval is the period between transmission of the periodic LLDP advertisements.The
default message transmit interval is 30 seconds.
Supermicro switches allow for user configuration of the message transmit interval. Follow the below steps
to change the message transmit interval.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
lldp transmit-interval <seconds(5-32768)>
(Optional)
Configuresthe message transmit
interval, range of 5-32768.
Step 3
End
Exits the configuration mode.
Step 4
show lldp
Displays the LLDP global information
The “no lldp transmit-interval” command resets the message transmit intervalto its default
value.