353 |341
ranges, separate with a comma (,).
E.g.: int range fx 0/1-10, fx 0/20
If multiple interfaces are provided, the
next step will perform the particular
configuration on all these interfaces.
lldptlv-select basic-tlv { [port-descr] [sys-name]
[sys-descr] [sys-capab] [mgmt-addr {all | ipv4
<ucast_addr> | ipv6 <ip6_addr>}]}
Enables the basic TLV transmission on a
given port
port-descr - Port description TLV
sys-name - System name TLV
sys-descr- System description TLV
sys-capab - System capabilities TLV
mgmt-addr all- Enables the
transmission of the management
address on the current interface. If no
management address is present or
configured in the system, the
switch’sMAC address will be usedfor
transmission.
mgmt-addr ipv4 ucast-addr - Enables
the transmission of a particular ipv4
address on the current interface.
mgmt-addr ipv6 ipv6-addr - Enables the
transmission of a particular ipv6
address on the current interface.
lldptlv-select dot1tlv {[port-vlan-id] [protocol-vlan-
id {all |<vlan-id>}] [vlan-name {all | <vlan-id>}]}
Configure dot1 TLV types to be
transmitted on a port
port-vlan-id - Port VLAN identifier TLV.
The keyword port-vlan-id keyword is
not supported.
protocol-vlan-id - Protocol VLAN
identifier TLV. The keyword protocol-
vlan-id is not supported.
vlan-name – VLAN name TLV
NOTE: VLANname must be configured
prior to this LLDP configuration.
To Next Page
Loading...
