352 |341
Figure LLDP-2: LLDP TLV Content
Enters the configuration mode
interface <interface-type><interface-id>
or
interfacerange <interface-type><interface-id> ….
(Optional) Enters the interface
configuration mode.
interface-type – may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
port-channel – po
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range use a hyphen (-)
between the start and end interface
numbers. E.g.: int range fx 0/1-10
To provide multiple interfaces or
•Chassis ID - Sender MAC address
•Port ID TLV - Sender Port number
•TTL - Time to Live
•End of LLDP PDU
Basic TLV -
Mandatory
•Port Description
•System Name
•System Description
•System Capabilities
•Management Address
Basic TLV -
Optional
•Port VLAN ID
•Port Protocol VLAN ID
•VLAN Name
•Protocol Identity
DOT1 TLV
•MAC/PHY Configuration (speed, duplex, negotiation, etc.)
•Link Aggregation TLV
•Maximum Frame Size TLV
DOT3 TLV
To Next Page
Loading...
