Supermicro SSE-F3548S - Page 301

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
301
cx-ethernet – cx
port-channel
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the “interface range …” command.
Toprovide a range, use a hyphen (-)
between the start and end interface
numbers. E.g.: int range fx 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range fx 0/1-10, fx 0/20
If multiple interfaces are provided, the
next step will perform the particular
configuration on all these interfaces.
Step 3
no snmp trap link-status
Disables the SNMP link-state trap on
the particular interface.
Step 4
end
Exits the configuration mode.
Step 5
show snmp
Displays the SNMP information.
Step 6
write startup-config
Optional step – saves this SNMP
configuration to be part of the startup
configuration.
The “snmp trap link-status” command enables SNMP link-state traps.
The example below shows the commands used to disable the SNMP Link-state trap.