Supermicro SSE-F3548S - Page 21

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
21
interface-type – Specify the interface
typethrough which the IP authorized
manager can access the switch.May be
any of the following:
fx-ethernet – fx
cx-ethernet – cx
interface-id is in slot/port format for all
physical interfaces.
vlan -Specify the vlan id through which
the IP authorized manager can access
the switch.
service – Specify the services that can
be accessed by the authorized manager
Step 3
End
Exits the configuration mode.
Step 4
show authorized-managers
Displays the Authorized Managers
configuration.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
If IP Authorized Managers are configured in a Supermicro switch, access to the switch via
telnet, ssh, etc. is possible only by those hosts allowed to access. Other hosts will not be
permitted access.
The “no authorized-manager ip-source <ip-address> [{<subnet-mask> | / <prefix-length(1-
32)>}]” command deletes the particular authorized manager.
The example below shows the commands used to configure Authorized Managers.
SMIS# configure terminal
SMIS(config)#authorized-manager ip-source 200.200.200.10 service telnet
SMIS(config)# authorized-manager ip-source 100.100.100.10 service http
SMIS(config)# end
SMIS# show authorized-managers
Ip Authorized Manager Table
---------------------------
Ip Address: 100.100.100.10
Ip Mask: 255.255.255.255