Supermicro SSE-F3548S - Page 61

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
61
Level 4 –Warning
Used for logging warning messages
Level 5 –Notification
Used for logging messages that require
attention but are not errors
Level 6 – Informational
Used for logging informational
messages.
Level 7 – Debugging
Used for logging debug messages.
Step 3
End
Exits the configuration mode.
Step 4
show logging
Displays the Syslog configuration.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The “no logging trap” command resets trap logging to its default value of ‘Critical’.
The example below shows the commands used to configure logging traps.
SMIS# configure terminal
SMIS(config)# logging trap 5
SMIS# end
SMIS(config)# show logging
System Log Information
----------------------
Syslog logging: enabled(Number of messages 0)
Console logging: disabled(Number of messages 0)
File logging: disabled(Number of messages 0)
Log File Name:
File Max Entries: 500
TimeStamp option: enabled
Trap logging: Notification
Log server IP: None
Facility: Default (local0)
Buffered size: 200 Entries
LogBuffer: (11 Entries)
<135> Apr 29 10:11:05 2013:DHC-7:Exitting DHCPC Task Ini
<135> Apr 29 10:11:05 2013:DHC-7:Entered in DhcpCIntSelectTaskMain fn