Supermicro SSE-F3548S - Page 140

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
140
Follow the below steps to configure the load balancing algorithm.
The “no port-channel load-balance” command resets the load balancing algorithm to the default
value of “src-dest-mac”.
The example below shows the steps necessary to configure the port channel load balancing algorithm.
Configure the load balancing algorithm based upon source and destination IP addresses.
SMIS# configure terminal
SMIS(config)# port-channel load-balance src-dest-ip
SMIS(config-if)# exit
The link aggregation feature is enabled by default in Supermicro switches. Users can disable link
aggregation if needed.
Follow the steps below to disable the link aggregation feature.
given port channel algorithm will be
applied to all port channel interfaces.
Step 3
End
Exits the configuration mode.
Step 4
show running-config
Displays the configured load balancing
information.
Step 5
write startup-config
Optional step – saves this load
balancing configuration to be part of the
startup configuration.