Supermicro SSE-F3548S - Page 303

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
303
<number>] }
ipv4_address – IPv4 address of Sub-
Agent
ipv6_address – IPv6 address of Sub-
Agent
number – UDP port number for SNMP
message reception/transmission at
Sub-Agent, in the range of 1-65535.
Step 3
end
Exits the configuration mode.
Step 4
show snmpagentx information
show snmpagentx statistics
Displays the SNMP Sub-Agent
information.
Step 5
write startup-config
Optional step – saves this SNMP
configuration to be part of the startup
configuration.
An SNMP Agent must be disabled before enabling an SNMP Sub-Agent.
The “disable snmpsubagent ”command disables the SNMP Sub-Agent.
The example below shows the commands used to enable the SNMP Sub-Agent.
SMIS# configure terminal
SMIS(config)# disable snmpagent
SMIS(config)# enable snmpsubagent master ip4 192.168.1.80
SMIS(config)# end
SMIS# show snmpagentx information
Agentx Subagent is enabled
TransportDomain:TCP
Master IP Address:192.168.1.80
Master PortNo:705
SMIS(config)# show snmpagentx statistics
Tx Statistics
Transmitted Packets:1
Open PDU:1
Index Allocate PDU:0
Index DeAllocate PDU:0
Register PDU:0
Add Agent Capabilities PDU:0
Notify PDU:0
Ping PDU:0
Remove Agent Capabilities PDU:0