Supermicro SSE-F3548S - Page 349

349 |341
interface-type – may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
port-channel – po
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range use a hyphen (-)
between the start and end interface
numbers. E.g.: int range fx 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range fx 0/1-10, fx 0/20
If multiple interfaces are provided, the
next step will perform the particular
configuration on all these interfaces.
Step 3
lldp {transmit | receive}
(Optional)
Sets LLDP admin status on an interface
to Transmit or Receive
Step 4
lldp notification [remote-table-chg][mis-
configuration]
(Optional)
Enables LLDP trap notification on an
interface.
remote-table-chg - Trap notification for
change in neighbor’s table.
mis-configuration - Trap notification for
mis-configuration.
Step 5
lldp port-id-subtype { if-alias | port-comp
<string(255)> | mac-addr | if-name | local
<string(255)> }
(Optional)
Configures LLDPport IDsubtype and
port IDvalue
if-alias - interface alias
port-comp - port component
mac-addr - MAC address
if-name - interface name
local - locally assigned