Supermicro SSE-F3548S - Page 129

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
129
Step 2
interface <interface-type><interface-id>
or
Enters the interface mode.
Interface-type - may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
interface range <interface-type><interface-id>….
Interface-id is in slot/port format for
allphysical interfaces.
To configure multiple interfaces,use the
"interface range..." commnad. To provide
a range, use a hyphen(
-) between the
start and end interface numbers. E.g.: int
range
fx0/1-10 To provide multiple
interfaces or ranges,
separate with a
comma(,).
E.g.: int range
fx 0/1-10,fx 0/1-20
Step 3
no channel-group
Removes the member ports from the
port channel.
Step 4
channel-group <channel-group-number> mode
Configures the interfaces as member
{active | passive | on}
ports with the given port mode.
For LACP aggregation, use the active or
passive mode.
For static link aggregation, use the
mode on.
channel-group-number – The port
channel to which these member ports
are added.
Step 5
End
Exits the interface configuration mode.
Step 6
show interface port-channel <channel-group-
Displays the configured port channel