Supermicro SSE-F3548S - Page 296

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
296
[{volatile | nonvolatile}]
ParamNameThe parameter to be
notified. Alphanumeric value with a
maximum of 40 characters.
UserName - Alphanumeric value with a
maximum of 40 characters.
Security model – Use one of v1, v2c, v3.
Use authto enable authentication for
the user.
Use privtoenableencryption of packets.
Message processing- Specifies the
SNMP version for sending/receiving the
parameter via a notification message.
Use volatileif the value need not be
stored in NVRAM.
Use nonvolatile if the value must be
stored in NVRAM and available after
restart.
Step 3
end
Exits the configuration mode.
Step 4
show snmptargetparam
Displays the SNMP target parameters
information.
Step 5
write startup-config
Optional step – saves this SNMP
configuration to be part of the startup
configuration.
The“no snmptargetparams<ParamName> ”command deletes the specified SNMP target
parameters information.
The example below shows the commands used to configure the SNMP target parameters.
SMIS# configure terminal
SMIS(config)# snmptargetparamsparam4 user user4 security-model v2c message-processing v2c
SMIS# end
SMIS# show snmptargetparam
Target Parameter Name: Internet
Message Processing Model: v2c
Security Model: v2c