Supermicro SSE-F3548S - Page 292

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
292
[{volatile | nonvolatile}]
a maximum of 40 characters.
Security model – Mention one of v1,
v2c or v3.
Use authto enable authentication for
the user.
Use privtoenableencryption of packets.
ReadView- View name that specifies
read access to particular MIB sub-
tree.Alphanumeric value with a
maximum of 40 characters.
WriteViewView name that specifies
write access to particular MIB sub-tree.
Alphanumeric value with a maximum of
40 characters.
NotifyViewView name that specifies a
particular MIB sub-tree used in
notification. Alphanumeric value with a
maximum of 40 characters.
Use volatileif the value need not be
stored in NVRAM.
Use nonvolatile if the value must be
stored in NVRAM and available after
restart.
Step 3
end
Exits the configuration mode.
Step 4
show snmp group access
Displays the SNMP group access
information.
Step 5
write startup-config
Optional step – saves this SNMP
configuration to be part of startup
configuration.
Group, user and view should be created before configuring group access.
The“
no snmp access <GroupName> {v1 | v2c | v3 {auth | noauth | priv}}”
commanddeletes the specified SNMP group access.
The sequence of steps to delete a group that is associated with a group access and view:
1. Delete the view
2. Delete the group access.