Supermicro SSE-F3548S - Page 289

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
289
stored in NVRAM and available after
restart.
Step 3
end
Exits the configuration mode.
Step 4
show snmp group
Displays the SNMP group information.
Step 5
write startup-config
Optional step – saves this SNMP
configuration to be part of the startup
configuration.
The “no snmp group <GroupName> user <UserName>security-model {v1 | v2c | v3}”
command deletes the specified group.
The example below shows the commands used to configure the SNMP group.
SMIS# configure terminal
SMIS(config)# snmp group group5 user user5 security-model v3
SMIS# end
SMIS# show snmp group
Security Model: v1
Security Name: none
Group Name: iso
Storage Type: Volatile
Row Status: Active
------------------------------
Security Model: v2c
Security Name: none
Group Name: iso
Storage Type: Volatile
Row Status: Active
------------------------------
Security Model: v3
Security Name: user5
Group Name: group5
Storage Type: Volatile
Row Status: Active
------------------------------
Security Model: v3
Security Name: initial
Group Name: initial
Storage Type: Non-volatile
Row Status: Active
------------------------------
Security Model: v3