Supermicro SSE-F3548S - Page 127

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
127
SMIS(config-if)# exit
4.6.2.4 Removing Member Ports
Follow the steps below to remove member ports from the port channel interfaces.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
interface <interface-type><interface-id>
Enters the interface mode.
Or
interface range <interface-type><interface-id>
interface-type – may be any of the
….
following:
fx-ethernet – fx
cx-ethernet – cx
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range, use a hyphen (-)
between the start and end interface
numbers.
E.g.: int range fx 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range fx 0/1-10, fx 0/20
Step 3
no channel-group
Removes the member ports from the
port channel.