Supermicro SSE-F3548S - Page 136

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
136
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range, use a hyphen (-)
between the start and end interface
numbers.
E.g.: int range fx 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range fx 0/1-10, fx 0/20
Step 3
lacp timeout {long | short}
Configures the LACP port timeout.
long – LACP messages are expected to
be received once every 30 seconds.
short – LACP messages are expected to
be received once every second.
Step 4
End
Exits the configuration mode.
Step 5
show running-config
Displays the configured port priority
information.
show etherchannel