Supermicro SSE-F3548S - Page 144

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
144
switchport mode trunk
interface po 3
switchport access vlan 10
switchport mode access
exit
SMIS#
# Check the port channels using the “show etherchannel” command
SMIS# show etherchannel detail
Port-channel Module Admin Status is enabled
Port-channel Module Oper Status is enabled
Port-channel System Identifier is 00:30:48:a1:11:01
LACP System Priority: 32768
Channel Group Listing
---------------------
Group: 1
Protocol: LACP
Ports in the Group
------------------
Port: Cx0/3
-------------
Port State = Down, Not in Bundle
Channel Group: 1
Mode: Active
Pseudo port-channel = Po1
LACP port-priority = 128
LACP Wait-time = 2 secs
LACP Activity: Active
LACP Timeout: Long
Aggregation State: Aggregation, Defaulted
Port: Cx0/4
-------------
Port State = Down, Not in Bundle
Channel Group: 1
Mode: Active
Pseudo port-channel = Po1
LACP port-priority = 128
LACP Wait-time = 2 secs
LACP Activity: Active
LACP Timeout: Long
Aggregation State: Aggregation, Defaulted
LACP Port Admin Oper Port Port Port State Priority Key Key Number State
---------------------------------------------------------------------
Cx0/3
Down
128
1
1
0x33
0x45
Cx0/4
Down
128
1
1
0x34
0x45
Port-channel: Po1