Supermicro SSE-F3548S - Page 174

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
174
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
To configure the hello time in RST mode:
spanning-tree hello-time<time-value>
Configures the hello time interval.
time-value – Hello time value may be 1
or 2 seconds.
The default hello time is 2 seconds.
Step 3
end
Exits the configuration mode.
Step 4
show spanning-tree interface <interface-
type><interface-id>
Displays the spanning tree port
parameters including the hello time
values.
Step 5
write startup-config
Optional step – saves this spanning tree
configuration to be part of startup
configuration.
The “no spanning-tree hello-time” command resets the spanning tree port hello time to the
default value of 2 seconds.
Follow the steps below to change the hello time for ports in MSTP.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
interface <interface-type><interface-id>
or
interface range <interface-type><interface-id> ….
Enters the port interface mode.
interface-type – may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
port-channel – po
interface-id is in slot/port format for all
physical interfaces. It may be the port
channel identifier for port channel
interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range use a hypen (-)
between the start and end interface
numbers.
E.g.: int range fx 0/1-10
To provide multiple interfaces or
ranges, use separate with a comma (,).
E.g.: int range fx 0/1-10, fx 0/20