Supermicro SSE-F3548S - Page 259

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
259
policed-dscp-transmit - changes the differentiated
services code point (DSCP) ofthe packet to that
specified in the policed-DSCP map and then sends the
packet. The DSCP range is 0-63.
Step
10
End
Exits theconfiguration mode.
Step
11
show class-map [<class-map-num(1-
65535)>]
show policy-map [<policy-map-
num(1-65535)> [class <class-map-
num(1-65535)>]
Displays the classmap configuration.
Displays the policy map configuration.
ACL cannot be modified unless it is removed from the class-map.
For modifying an ACL associated with a classmap, follow the steps below:
1) Remove policy map
2) Remove classmap
3) Modify the ACL
4) Re-create the classmap
5) Re-create the policymap
If required, an ACL’s association with an interface must be configured before the “class-
map” configuration,i.e. after associating the ACL with a classmap using the
“match”command, the ACL cannot be associated with an interface.
These commands either delete the particular configuration or reset it to its default value.
no class-map <class-map-number(1-65535)>
no policy-map <policy-map-number(1-65535)>
no class <class-map-number(1-65535)>
Before deleting a classmap, any policy map associated with it must first be deleted.
The example below shows the commands used to configure QoS classification, marking and policing.
Example 1: Classification and Marking
Create a Layer 2 MAC ACL with two permit statements and attach it to an ingress interface. The first
permit statement allows traffic from the host with a MAC address of 00:30:48:14:c8:29to be sent to any
host.
SMIS# configure terminal
SMIS(config)# mac access-list extended mac1
SMIS(config-ext-macl)# permit host 00:30:48:14:c8:29 any
SMIS(config-ext-macl)# exit
SMIS(config)# set qos enable
SMIS(config)# interface Fx 0/3