Supermicro SSE-F3548S - Page 26

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
26
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range use a hyphen (-)
between the start and end interface
numbers. E.g.: int range cx 0/1-2
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range cx 0/1-2, cx 0/3
If multiple interfaces are provided, the
next step will perform the particular
configuration on all these interfaces.
Step3
Negotiation
Enable Interface Negotiation
Step 4
End
Exits the configuration mode.
Step 5
show interface status
Displays the interface configuration.
Step 6
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The “no negotiation” command disables interface negotiation.
The example below shows the commands used to configure Interface Negotiation.
SMIS# configure terminal
SMIS(config)# interface Cx 0/2
SMIS(config-if)# no negotiation
SMIS(config-if)# end
SMIS
# sh int status
Port Status Duplex Speed Negotiation
---- ------ ------ ----- -----------
Fx0/1 not connected Full 10 Gbps No-Negotiation
Fx0/2 not connected Full 10 Gbps No-Negotiation
Fx0/3 not connected Full 10 Gbps No-Negotiation