Supermicro SSE-F3548S - Page 267

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
267
The example below shows the commands used to configure QoS default priority, scheduling and
bandwidth.
Example 1: Default Priority
SMIS# configure terminal
SMIS(config)# interface Fx 0/10
SMIS(config-if)# switchport priority default 5
SMIS(config-if)# end
SMIS# show vlan port config port Fx 0/10
Vlan Port configuration table
-------------------------------
Port Fx0/10
Port Vlan ID : 1
Port Access Vlan ID : 1
Port Acceptable Frame Type : Admit All
Port Ingress Filtering : Disabled
Port Mode : Hybrid
Port Gvrp Status : Disabled
Port Gmrp Status : Disabled
Port Gvrp Failed Registrations : 0
Gvrp last pdu origin : 00:00:00:00:00:00
Port Restricted Vlan Registration : Disabled
Port Restricted Group Registration : Disabled
Mac Based Support : Disabled
Port-and-Protocol Based Support : Enabled
Default Priority : 5
Filtering Utility Criteria : Default
Allowed Vlans on Trunk : 1-4069