Supermicro SSE-F3548S - Page 273

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
273
Once the source port is used in a session, to use it in another session, user needs to remove the source
port first. If not, the recently input source port will overwrite the previous source port.
The “no monitor session [session_number:1-4] destination interface <interface-type>
<interface id> " command delete the destination port mirroring.
The "no monitor session [session_number:1-4] source interface <interface-type>
<interface-id>” command deletes the source port mirroring.
Note that in the command to remove the source port, there is no provision for the direction
field {rx ,tx, both}.
The example below shows the commands used to configure Port Mirroring.
SMIS# configure terminal
SMIS(config)# monitor session destination interface fx 0/48
SMIS(config)# monitor session source interface fx 0/22
SMIS(config)# monitor session source interface fx 0/23
SMIS(config)# monitor session source interface fx 0/24
SMIS(config)# monitor session source interface fx 0/25
SMIS(config)# end
SMIS# show port-monitoring
Port Monitoring is enabled
Monitor Port : Fx0/48
Port Ingress-Monitoring Egress-Monitoring
---- ------------------ -----------------
Fx0/1 Disabled Disabled
Fx0/2 Disabled Disabled
Fx0/3 Disabled Disabled
Fx0/4 Disabled Disabled
Fx0/5 Disabled Disabled
Fx0/6 Disabled Disabled
Fx0/7 Disabled Disabled
Fx0/8 Disabled Disabled
Fx0/9 Disabled Disabled
Fx0/10 Disabled Disabled
Fx0/11 Disabled Disabled
Fx0/12 Disabled Disabled
Fx0/13 Disabled Disabled
Fx0/14 Disabled Disabled
Fx0/15 Disabled Disabled
Fx0/16 Disabled Disabled