Supermicro SSE-F3548S - Page 95

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
95
or
no ports [<ports-list>] untagged
VLAN.
ports-list – up to three ports or three
ranges of ports separated by spaces.
The range of ports is provided in the
format fx 0/1-10, which specifies the
ports from fx 0/1 to fx 0/10.
Use the no form of this command to
remove untagged ports from this VLAN.
If ports-list is not provided to the no
command, all the untagged ports are
removed from this VLAN.
Step 3c
ports <ports-list> forbidden
or
no ports [<ports-list>] forbidden
Denies traffic from ports given by
ports-list to this VLAN.
ports-list – up to three ports or ranges
of ports separated by spaces.
The range of ports is provided in the
format fx 0/1-10, which specifies the
ports from fx 0/1 to fx 0/10.
Use the no form of this command to
remove forbidden ports from this
VLAN.
If ports-list is not provided to the no
command, all the forbidden ports are
removed from this VLAN.
Step 4
Exit
Exits the VLAN configuration mode.
Step 5
interface <interface-type> <interface-id>
or
interface range <interface-type> <interface-id>
….
Enters the interface mode.
interface-type – may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
port-channel – po
interface-id is in slot/port format for all
physical interfaces. It may be a port
channel identifier for port channel
interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range, use a hypen (-)
between the start and end interface
numbers.
E.g.: int range fx 0/1-10
To provide multiple interfaces or