Supermicro SSE-F3548S - Page 98

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
98
Follow the steps below to configure MAC based VLANs.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
vlan <vlan-list>
Creates the required VLANs.
vlan-list – may be any VLAN number or
list of VLAN numbers. Multiple VLAN
numbers can be provided as comma
separated values. Consecutive VLAN
numbers can be provided as ranges
such as 5-10.
Step 3
ports <ports-list> untagged
Adds the ports given by ports-list to
this VLAN as untagged ports.
ports-list – up to three ports or ranges
of ports separated by spaces.
The range of ports is provided in the
format fx 0/1-10, which specifies the
ports from fx 0/1 to fx 0/10.
Step 4
Exit
Exits the VLAN configuration mode.
Step 5
mac-vlan <ucast_mac> vlan <vlan-id>
Configures MAC VLAN mapping entry.
ucast_mac – Unicast MAC address.
This VLAN will be applied to all
incoming untagged packets from this
unicast MAC address.
vlan-id - VLAN identifiers may be any
VLAN number from 1 to 4069. The
VLAN must have already been created
in this switch.
00:30:48:01:72:58
VLAN 20
Switch
00:30:48:0a:dd:e3
VLAN 10
00:30:48:04:02:89
VLAN 20
00:30:48:d8:ed:54
VLAN 30
MAC Address
VLAN
00:30:48:0a:dd:e3
10
00:30:48:04:02:89
20
00:30:48:01:72:58
20
00:30:48:d8:ed:54
30