CLUTCH 7-7
OIL SEAL AND BEARING
• Inspect the oil seal for damage and oil leakage.
• Inspect the bearings for abnormal noise, wear and damage.
OIL SEAL REMOVAL AND INSTALLATION (10-9, -10)
BEARING REMOVAL AND INSTALLATION (10-12, -13)
INSTALLATION
Install the clutch assembly in the reverse order of removal. Pay
attention to the following points.
PRIMARY DRIVEN GEAR
• Apply transmission oil to the spacer 1 and needle bearing 2.
• Fit the primary driven gear assembly 3 and washer 4.
• Fit the clutch sleeve hub 5, new lock washer 6 and clutch
sleeve hub nut 7.
NOTE:
The flat side of the nut 7 must face outside.
To Next Page
