COOLING SYSTEM 12-7
REASSEMBLY
Reassemble the water pump in the reverse order of removal.
Pay attention to the following points:
• Apply THREAD LOCK SUPER to the outer surface of the oil
seal.
99000-32110: THREAD LOCK SUPER “1322”
(or equivalent thread lock)
• Press the oil seal with the suitable size socket wrench.
• Apply grease to the oil seal lip.
99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Install a new bearing with the special tool.
09913-70210: Bearing installer set
NOTE:
When installing the bearing, the stamped mark on the bearing
must face outside.
• Hold the water pump shaft with a wrench and tighten the
impeller bolt to the specified torque.
Impeller: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
CAUTION
The impeller has left-hand threads.
To Next Page
Loading...
