Suzuki RM250 - Reassembly

17-18 REAR SUSPENSION
• Remove the needle roller bearing cage 1 with the special
tool.
 09921-20240: Bearing remover set
• Apply grease to the bearings.
 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Press fit the bearing cage with the special tool.
 09913-70210: Bearing installer set
• Apply grease to the bearings.
 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Press fit the bearing cage with the special tool and a suitable
size socket wrench.
 09924-84521: Bearing installer set
NOTE:
Position the bearings by refering to the illustration of page 17-
19.
REASSEMBLY
Reassemble and remount the rear suspension linkage in the
reverse order of removal and disassembly. Pay attention to the
following points:
• Position the dust seals 1 so that the manufacturer’s code
indicated side of the seals face outside. (2: inside)
• Apply grease to the spacers and dust seals.
 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)