ELECTRICAL SYSTEM 13-7
INSPECTION
IGNITION SYSTEM PEAK VOLTAGE
• Remove the seat and fuel tank. (5-4)
• Remove the spark plug.
• Disconnect the magneto lead wire coupler 1.
Measure the ignition system peak voltage in the following proce-
dure:
• Connect the multi-circuit tester with the peak volt adaptor as
follows. (See table below.)
• Measure the highest peak voltage by depressing the kick
starter lever several times forcefully.
Tester knob indication: Voltage ()
09900-25008: Multi-circuit tester
• Connect the magneto lead wire coupler and disconnect the
ignition coil lead wire coupler 2.
Exciter + Black/Red – - Red/White 25 V and more
Pick-up + Red – - Green 2 V and more
Charge + Yellow – - Black/White 8 V and more
R/W
G
R
B/R
Y
B/W
To Next Page
Loading...
