Suzuki RM250 - Clutch Plate

7-8 CLUTCH
• Tighten the clutch sleeve hub nut with the special tool to the
specified torque.
 Clutch sleeve hub nut: 90 N·m (9.0 kgf-m, 65.0 lb-ft)
 09920-53740: Clutch sleeve hub holder
• Bend the lock washer to secure the nut.
CLUTCH PLATE
• Apply transmission oil to the drive plates and driven plates.
• Install the clutch drive plates and driven plates.
• Apply transmission oil to the bearing.
• Insert the clutch push rod.
• Insert the clutch push piece and bearing. The covered side A
of the bearing should face outside.
• Fit the pressure plate 1.
• Insert the springs and tighten the bolts diagonally to the spec-
ified torque.
 Clutch spring bolt: 5 N·m (0.5 kgf-m, 3.5 lb-ft)
Outside