Suzuki RM250 - Gearshifting Reassembly Procedures

9-6 GEARSHIFTING
REASSEMBLY
• Temporarily install the spring 1, washer 2 and gearshift cam
stopper 3.
• Hook the spring 1 to the projection A.
• Tighten the gearshift cam stopper bolt.
• Align the pin groove B with the pin C when installing the
stopper plate 4.
• Tighten the gearshift cam bolt 5.
 Gearshift cam bolt: 23.5 N·m (2.35 kgf-m, 17.0 lb-ft)
• Apply THREAD LOCK SUPER and tighten the gearshift arm
stopper bolt 6 to the specified torque.
 Gearshift arm stopper bolt: 20 N·m (2.0 kgf-m, 14.5 lb-ft)
99000-32030: THREAD LOCK SUPER “1303”