Suzuki RM250 - Engine Bottom Side Removal

10-4 TRANSMISSION AND CRANKSHAFT
ENGINE BOTTOM SIDE
• Dismount the engine. (5-4)
NOTE:
The following parts must be removed before disassembling the
engine bottom side (crankcase).
• Remove the engine sprocket 1.
• Remove the gearshift lever. (9-3)
• Remove the kick starter lever. (8-3)
• Remove the cylinder head, cylinder and piston. (6-5)
• Remove the crankcase cover and clutch. (8-3, 7-3, -4)
• Remove the kick starter idle gear and kick starter shaft.
(8-3)
• Remove the gearshift linkage. (9-3)
• Remove the exhaust valve governor. (6-19)
 09900-06107: Snap ring pliers
PRIMARY DRIVE GEAR REMOVAL
• Hold the crankshaft immovable with the special tool.
 09930-40113: Rotor holder
• Remove the primary drive gear bolt 1.