Suzuki RM250 - Handlebar Controls Service

FRONT FORK AND STEERING 16-17
HANDLEBAR CONTROLS
CONSTRUCTION
REMOVAL
• Place the motorcycle on a block to lift front wheel off the
ground.
• Remove the front number plate. (5-2)
• Remove the protector 1.
• Remove the clamps.
• Remove the clutch lever.
• Remove the engine stop switch 2.
• Remove the left handle grip 3.
NOTE:
Mark the paint mark to the matching surface of clutch lever
holder and handlebars, left handle grip and handlebars before
removing.
Adhesive agent
6 N·m
(0.6 kgf-m, 4.4 lb-ft)
6 N·m
(0.6 kgf-m, 4.4 lb-ft)
Adhesive agent
25 N·m
(2.5 kgf-m, 18.0 lb-ft)