FRONT AND REAR WHEELS 14-3
REMOVAL
• Place the motorcycle on a block to lift front wheel off the
ground.
• Remove the axle nut 1.
• Loosen the left axle holder bolts 2.
• Loosen the right axle holder bolts 3.
• Remove the front axle shaft 4.
• Remove the front wheel and spacers.
INSPECTION
SPACER AND DUST SEAL
• Inspect the left and right wheel spacers and dust seals for
wear and cracks.
• If any damage is found, replace the spacer together with the
dust seal.
NOTE:
Apply grease to the spacer and dust seal when reassembling.
99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
AXLE SHAFT
Support the axle shaft with V-blocks and measure the axle shaft
runout.
Wheel axle runout
Service limit: 0.25 mm (0.010 in)
09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
WHEEL RIM (2-21)
Wheel rim runout
Service limit: 2.0 mm (0.08 in) ... axial and radial
To Next Page
Loading...
