FUEL SYSTEM 11-7
REASSEMBLY AND REMOUNTING
Reassembly and remounting is in the reverse order of removal
and disassembly. Pay attention to the following points:
• Fit the projection of the throttle valve collar into the groove of
cable holder.
• Set the throttle position sensor guide roller upon the throttle
valve.
• Fit the projection on the carburetor body in the depression of
the intake pipe.
• Position the carburetor clamps as shown.
• Rout the cable and hoses properly. (18-14, -15)
Left
Right
Engine side
Air cleaner side
Left
Right
45˚
To Next Page
Loading...
