The Measurement list contains the following positions:
General Settings allowing to set up general measurement parameters;
Measurement Trigger allowing to set up the measurement trigger;
Profiles allowing to program the profile parameters;
Logging allowing to program the logging function;
Spectrum allowing to set up octave spectrum parameters. This position appears in the
Measurement list in case of 1/1 or 1/3 octave functions;
FFT allowing to set up spectrum parameters. This position appears in the
Measurement list in case of FFT function;
RT60 allowing to set up RT60 parameters. This position appears in the Measurement
list in case of RT60 function;
Compensation Filter allowing to switch on the required microphone compensation filter;
Range allowing to select the correct measurement range;
RPM Measurement allowing to set up the RPM measurements parameters;
Exposure Time allowing to set the daily exposure time for dose measurements;
Statistical Levels allowing to define 10 statistical levels;
Timer allowing to programme the internal real-time clock to act as a delayed start timer;
Alarms allowing to check the status of the advanced alarm function. This position
appears in the Measurement list in the case the ALARM.SVA file is uploaded
to the predefined SYSTEM catalogue.
The content of the Measurement list depends
on settings of Mode and
Measurement Function. Examples for two
different modes and measurement functions are
presented.
Any parameter in the Measurement list can be changed only when the
instrument is not currently executing a measurement. The parameters are
displayed with grey colour. The blinking „measurement” icon indicates that the
instrument is performing a measurement.
To Next Page
Loading...
