Svantek SVAN 977A - 8.10. Introducing the instrument name - Unit Name; 8.11. Checking the instrument properties - Unit Label

86
SVAN 977A User Manual
Disabling of Default Port will initiate the Port position, where the user will be
able to define its own port.
Editing of some positions is performed in the special screen with the text editor function, which is opened after
pressing the ◄ / ► key.
8.10. INTRODUCING THE INSTRUMENT NAME - UNIT NAME
The Unit Name position allows to edit the
instrument’s name in the text editor screen.
The instrument name is used in the SvanNET
web-service and SvanPC++ software for the
instrument simple identification.
<ENT>
8.11. CHECKING THE INSTRUMENT PROPERTIES - UNIT LABEL
The Unit Label position allows to check
information about the instrument type, its
serial number, the current software version
installed and the relevant standards, which
the instrument fulfils.
The displayed text is scrolled on the display
after pressing the ▲ / ▼ key.
<ENT>
Note: The contents of the Unit Label screen should be always sent to the Svantek service
department or official representative in case of any problems faced by the user during the instrument’s
normal operation.