9 AUXILIARY SETTINGS – Auxiliary Setup
The Auxiliary Setup section provides
additional functions that allow, for instance,
customization of the device interface to a
specific user requirement and are not directly
related to the hardware components of the
instrument.
The Auxiliary Setup section contains following positions:
Language allowing to select the language of the user interface.
Factory Settings allowing to return to the default, factory settings.
Reference Levels allowing to select reference levels for Vibration measurements.
Vibration Units allowing to select units for Vibration results. This position appears only in
Vibration modes.
Warnings allowing to enable/disable warnings to be displayed during the normal operation
of the instrument.
9.1. SELECTING THE USER INTERFACE LANGUAGE – LANGUAGE
The Language position enables selecting
language of the user interface.
If after turning the instrument on an unknown
language interface appears on the display,
you can reset the instrument with four <Shift/
Enter/Alt/Start> keys pressed together. After
this, the instrument will come back to the
default setup with the English interface.
9.2. RESTORING THE FACTORY SETTINGS – FACTORY SETTINGS
The Factory Settings position allows to
restore the default settings of the instrument.
Being on the Factory Settings position press
<ENTER>, select Yes in the opened
Factory Settings screen and press
<ENTER> to perform the operation. After the
restoration process the instrument will inform
that “Settings restored”.
The factory settings can be installed also with four <Shift/Enter/Alt/Start> keys pressed together.
9.3. SETTING THE REFERENCE LEVELS - REFERENCE LEVELS
The Reference Levels position allows to set
reference levels for the measured
acceleration (Acc), velocity (Vel) and
displacement (Dil) results. For sound
measurements it only informs about the
default reference sound level. The selected
values will be considered during calculations
of measurement results expressed in dB
(Logarithmic scale).
To Next Page
Loading...
