4.12. Device Configuration
• “monitor/heartbeat interval” is enabled and used when the I-
™ is being utilized as a static monitoring device. The factory de-
fault is disabled. Interval can range from 2 seconds to 1800 seconds.
Warning If the Bluetooth® technology is disabled, none of this feature’s
functionality is available. s
Bluetooth® RS232 Settings:
• “Bluetooth® address” contains the address of the Bluetooth® RS232
device in use when “using Bluetooth® RS232 device” is selected in the
general Reach-Back Settings.
Bluetooth® DUN/Modem Settings:
• “modem pin” is the pin number to access the wireless telephone mo-
dem.
• “dialup number” is the number the wireless modem dials for “push”
reach-back.
• “user” and “password” are the required username and passwords to
access the reach-back server. These may or may not be in use on the
server.
• “reach back ip” is the IP address of the reach-back or back-end server.
The port is fixed to 8003.
• “Conn. String” is the connection string used to access DUN features
on devices such as a Blackberry®.
Warning Each of the DUN/Modem settings are required when using
DUN/modem except for user and password which are dependent upon the
user’s dial-up data provider. s
Reach-Back Configuration:
• “spectrum”, “id results”, “voice”, and “image” can be selected for in-
clusion in the reach-back data package. The ID results are always in-
cluded, but the spectrum, voice, and image files are optional.
Thermo Fisher Scientific Interceptor™/en/5.1(4956)/Feb2010 85
To Next Page