6. TROUBLESHOOTING
I HAVE A BLUETOOTH® GPS ENABLED DEVICE BUT IT DISPLAYS “NO
MODULE” DURING IDENTIFICATION.
Check the GPS receiver and verify that it is turned on and adequately
charged. If this is not the case, then connect the GPS module to a power
source via USB and charge the unit. If the GPS module appears to be operat-
ing correctly, open the Device Settings for the device using I™
Sync and verify that the Bluetooth GPS option is enabled and a valid device
address is entered.
I HAVE A BLUETOOTH® GPS ENABLED DEVICE BUT IT DISPLAYS
“INVALID GPS” DURING IDENTIFICATION.
Check the GPS receiver and verify that it is receiving a satellite signal. To
receive a satellite signal, the device must be exposed to the sky.
I HAVE A REACH-BACK ENABLED DEVICE BUT WHEN I SYNCHRONIZE MY
REACH-BACK SETTINGS, IT DOES NOT PROVIDE A REACH-BACK BUTTON
FOLLOWING THE IDENTIFICATION.
All Bluetooth® features require a re-boot of the device to activate them.
I AM USING MY WIRELESS PHONE FOR REACH-BACK BUT IT DOES NOT
SEND ANY DATA EVEN THOUGH I AM USING THE CORRECT BLUETOOTH®
ADDRESS IN THE REACH-BACK CONFIGURATION.
In order to be compatible with reach-back, the wireless phone must be Blue-
tooth® equipped with modem and dial-up networking (DUN).
110 Interceptor™/en/5.1(4956)/Feb2010 ICx Technologies
To Next Page
Loading...
