OPTIONS & ALLIED TOOLING − DECO 7/10 − DECO 7a/10a − DECO 7e/10e
300236 en − 02/07 Chap. 17. /4
REPLACING REAR SPINDLE−SPRING BUSHING
(Use Assembly Tooling 010, 020, 250 and 260 included in the option.)
What to do ? Notes
− Take down the headstock guard.
− Remove Barguide-Tube Support
100.
− Screw in Rod 010 in the spindle.
− Fit Roller Bearing 250, Screwed
Sleeve 020, Nut 260 on Rod 010
and screw Sleeve 020...
... until it leans against Bushing
040.
− Tighten Nut 260 by approx. 0.5 mm
to release the elastic SEEGER ring.
− Remove the elastic SEEGER ring.
− Unscrew completely Nut 260.
− Remove Bushing 040 without
bores.
− Fit Bushing 040 with bores.
− Fit again Roller Bearing 250,
Screwed Sleeve 020, Nut 260 on
Rod 010.
− Retighten and fit in place the elastic
SEEGER ring.
− Take down Assembly Tooling 010,
020, 250 and 260.
FITTING NOTCHED DISK
What to do ? Notes
− Align approximately the spindle key
located forward in the headstock.
− Fit Notched Disk 030 in the back of
the spindle.
(Align approximately the spindle
key and the next notch).
− Tighten Screws 240 with 2 Nm
torque as indicated on the unit.
To Next Page
