4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 83
(4) Remove 2 screws, and then take off the
plate.
Notes:
The direction of the plate differs depending
on the destination (A4/LT).
Fig. 4-242
(5) Disconnect 1 connector, and then take off the
stopper opening/closing solenoid (front).
(6) Disconnect 1 connector and release 3
latches. Then take off the stopper opening/
closing detection sensor (front).
Fig. 4-243
Stopper opening/closing detection sensor (front)
Stopper opening/closing solenoid (front)
To Next Page
Loading...
