Toshiba e-studio 6560c - Page 258

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 84
4.5.54 Stopper opening/closing solenoid (rear)/Stopper opening/closing
detection sensor (rear) (S111)
(1) Take off the tandem LCF feeding unit.
 P. 4-82"4.5.52 Tandem LCF feeding unit"
(2) Remove 2 screws, release 2 hooks and then
take off the stopper unit.
Notes:
The position of the hook differs depending on
the destination.
Fig. 4-244
(3) Remove 2 screws, and then take off the
plate.
Notes:
The direction of the plate differs depending
on the destination (A4/LT).
Fig. 4-245
(4) Disconnect 1 connector, and then take off the
stopper opening/closing solenoid (rear).
(5) Disconnect 1 connector and release 3
latches. Then take off the stopper opening/
closing detection sensor (rear).
Fig. 4-246
Stopper unit
LT
Plate
Stopper opening/closing detection sensor (rear)
Stopper opening/closing solenoid (rear)