4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 187
(16) Take off the fuser roller from the fuser belt.
Notes:
• Since the fuser roller is easily damaged
such as being torn when its surface is
rubbed by your fingers or nails, be sure to
hold its shaft or guide.
• Make sure that no dust or similar adheres
to the surface of the fuser roller. If there is
any tear, flaw or crack on its surface,
replace it with a new one.
• Make sure that no dust or similar adheres
to the surface of the fuser belt. If there is
any flaw on its surface or any bent edge,
replace it with a new one.
• When replacing or taking off the fuser belt
and fuser roller, check the gap between
the belt and its thermostat.
P. 6-96"6.11.1 Gap adjustment for
fuser belt thermostats"
• Install the new fuser belt with its
protection sheet wound around it. After
installing the fuser belt unit, peel off the
protection sheet.
Fig. 4-542
Fig. 4-543
Notes:
Be sure to hold the fuser belt carefully since
it is easily damaged and not to pinch its
edges since the belt will be creased and torn.
Put your hand inside the belt when holding it.
Fig. 4-544
To Next Page
Loading...
