e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING ADJUSTMENT
6 - 114
(8) When the RADF is closed, check if the hole
of the adjustment plate on the right-hand
hinge is aligned with the hole on the
equipment. If it is not, turn the adjustment
screw to match the hole.
Fig.6-91
(9) Install 1 fixing screw (rear side) on the right-
hand hinge bracket.
Fig.6-92
(10) Insert a washer, and install 1 fixing screw
(rear side) on the left-hand hinge bracket.
Fig.6-93
To Next Page
Loading...
