6
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SETTING ADJUSTMENT
6 - 115
(11) Tighten the 2 fixing screws (front side) on the
hinge bracket.
Fig.6-94
(12) Open the RADF and remove 2 positioning
pins.
Fig.6-95
(13) Install 2 screws.
Fig.6-96
(14) Place the platen sheet on the original glass
and align it to the top left corner.
Close the RADF gently and open it to check
if the platen sheet is attached properly.
Fig.6-97
To Next Page
Loading...
