8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 13
EA31 Finisher jam
(Finisher section)
Transport path paper remaining jam:
[MJ-1103/1104]
P. 8-92
EA32 Exit paper remaining jam:
[MJ-1103/1104]
P. 8-93
EA40 Door open jam:
The upper/front cover of the finisher section
or the upper/ front door of the puncher
section has opened during printing. [MJ-
1103/1104]
Cover open error:
The front cover or stationary tray cover is
opened during paper transport. [MJ-1103/
1104]
P. 8-93
EA50 Stapling jam: Stapling is not performed
properly. [MJ-1103/1104]
P. 8-94
EA60 Early arrival jam: [MJ-1103/1104] P. 8-94
EA70 Stack exit belt home position error: The
stack exit belt is not at the home position.
[MJ-1103/1104]
P. 8-95
EA90 Finisher jam
(Saddle stitcher
section)
Door open jam: [MJ-1104]. P. 8-95
EAA0 Power-ON jam: [MJ-1104] P. 8-96
EAB0 Transport stop jam: The paper which
passed through the inlet sensor does not
reach or pass No.1 paper sensor, No. 2
paper sensor, No.3 paper sensor or
delivery sensor. [MJ-1104]
P. 8-96
EAB1 Short paper jam (Saddle Stitch Finisher).
[MJ-1104]
P. 8-97
EAD0 Other paper jam Print end command time-out jam: The
printing has not finished normally because
of an error occurring on the interface
between the SYS board and the engine
firmware at the end of printing.
P. 8-98
EAE0 Finisher jam Receiving time-out jam P. 8-99
EB30 Ready time-out jam P. 8-99
EB50 Paper transport jam Paper remaining on the transport path: The
multiple feeding of preceding paper caused
the misfeeding of upcoming paper.
P. 8-64
EB60 Paper remaining on the transport path: The
multiple feeding of preceding paper caused
the misfeeding of upcoming paper
(redetection after no jam is detected at
[EB50]).
P. 8-65
ED10 Finisher jam Skew adjustment motor (M1) home position
detection abnormality
P. 8-100
ED11 Sideways adjustment motor (M2) home
position detection error
P. 8-100
ED12 Shutter home position error P. 8-101
ED13 Front alignment plate home position error P. 8-101
Error code Classification Contents Troubleshooting
To Next Page
Loading...
